4. Conrm that the top (PO
WER) LED on the lower left front side of the controller is lit
amber, as shown in the following gure. If the storage system has a drive tray,
conrm that the POWER LED on the lower left front side of the drive tray is lit green.
Item Description
1 POWER LED on the front of the controller
5. On the lo
wer left front side of the controller, press and hold the POWER ON/OFF
button until the POWER LED changes to green (about 3 seconds), and then release
the button.
Item Description
1 Controller (front bezel attached)
2 Controller (front bezel removed)
3 READY LED on controller (front bezel removed)
4 POWER LED on controller (front bezel removed)
5 READY LED on controller (front bezel attached)
6 POWER LED on controller (front bezel attached)
Step 3: Power on the storage system
Installing your storage system that includes an SVP
Hitachi Virtual Storage Platform G130 (with SVP) Installation Guide 6
To Next Page
Loading...
