Hitachi VSP G1500 - Page 360

raidcom modify port -loop_id
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 054E The specified topology is invalid.
CMDRJE Executing B955 05A6 The other than "fabric on" cannot be specified
when specifying a topology of the package for
Fibre Channel over Ethernet.
CMDRJE Executing B955 05A7 The other than "P-to-P (point to point)" cannot be
specified when specifying a topology of the
package for Fibre Channel over Ethernet.
CMDRJE Executing B955 060F The specified LDEV is not installed.
CMDRJE Executing B955 06C0 The specified LDEV is being used as a volume of a
GAD pair.
CMDRJE Executing B955 06C1 The specified LDEV is used as a quorum disk.
CMDRJE Executing B955 06C2 The specified LDEV is used for a TrueCopy pair or a
Universal Replicator pair.
CMDRJE Executing B955 1039 The command device being used at the local CCI
exists under the port.
CMDRJE Executing B955 104F The program product is not installed.
CMDRJE Executing B955 113D Invalid host speed is set for the 4Gbps fibre
adapter. The available host speeds are AUTO, 1G,
2G, and 4G only.
CMDRJE Executing B955 113F Invalid host speed is set for the 8Gbps fibre
adapter. The available host speeds are AUTO, 2G,
4G, and 8G only.
CMDRJE Executing B955 11A5 The other than "10G" cannot be specified when
specifying a host speed of the package for Fibre
Channel over Ethernet.
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS Platform (System LU).
CMDRJE Executing B980 B902 The command was rejected because the selected
port is for NAS Platform (User LU).
Table 9-17 SSB codes returned by raidcom modify port -topology
raidcom modify port -topology
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 01C1 The specified LDEV is used as a quorum disk.
CMDRJE Executing B955 020F The specified LDEV is not installed.
CMDRJE Executing B955 0304 An LU path or a logical path has been defined.
CMDRJE Executing B955 0404 An LU path or a logical path has been defined.
9-36
Troubleshooting
Command Control Interface User and Reference Guide