Hitachi VSP G1500 - Page 512

raidcom add license
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2EC0 0102 This program product requires a higher-version
hardware product.
CMDRJE Executing 2EC0 0103 To use this program product, increase the shared
memory allocation, and enable the program
product.
CMDRJE Executing 2EC0 0108 This program product requires another type of
DKC.
CMDRJE Executing 2EC0 010D The specified program product is not supported.
CMDRJE Executing 2EC0 0130 The model information for the license key code is
not correct.
CMDRJE Executing 2EC0 0200 The specified number of extended days is shorter
than the number of trial days.
CMDRJE Executing 2EC0 0201 The program product cannot be enabled because
the license capacity is insufficient.
CMDRJE Executing 2EC0 0204 The license capacity is insufficient. The program
product is installed, but it will be invalid if the
license capacity is not increased before the
contract period expires.
CMDRJE Executing 2EC0 0206 The status of the specified license is already
changed or incorrect.
CMDRJE Executing 2EC0 050C With the current DKCMAIN firmware version, the
program product cannot be installed.
CMDRJE Executing 2EC0 2E01 The specified operation is not supported in the
current microcode version.
Table 9-153 SSB codes returned by raidcom delete license (VSP Gx00 models and VSP
Fx00 models)
raidcom delete license
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2EC1 0009 No program product is supported.
CMDRJE Executing 2EC1 0051 To remove this program product, remove or
disable the related program products first.
CMDRJE Executing 2EC1 0081 The specified program product ID is invalid.
CMDRJE Executing 2EC1 0104 To remove this program product, the configuration
must be changed.
CMDRJE Executing 2EC1 0105 This program product cannot be removed because
it is being used.
9-188
Troubleshooting
Command Control Interface User and Reference Guide