Hitachi WJ200-001S - Page 55

53
Standard Functions
NOTE:. Mark “” in b031=10 shows the accessible parameters when b031 is set “10”, high
level access.
“A” Function
Run
Mode
Edit
Defaults
Func.
Code
Name
Description
Initial data
Units

Frequency source
Eight options; select codes:
 POT on ext. operator
 Control terminal
 Function F001 setting
 Modbus network input
 Option
 Pulse train input
 via EzSQ
 Calculate function output

01


Frequency source,
2
nd
motor

01


Run command source
Four options; select codes:
 Control terminal
 Run key on keypad, or
digital operator
 Modbus network input
 Option

01


Run command source,
2
nd
motor

01


Base frequency
Settable from 30 Hz to the
maximum frequency()

50.0
Hz

Base frequency,
2
nd
motor
Settable from 30 Hz to the 2
nd
maximum frequency()

50.0
Hz

Maximum frequency
Settable from the base
frequency to 400(1000)
*1
Hz

50.0
Hz

Maximum frequency,
2
nd
motor
Settable from the 2
nd
base
frequency to 400(1000)
*1
Hz

50.0
Hz

[AT] selection
Three options; select codes:
...Select between [O] and [OI]
at [AT] (ON=OI, OFF=O)
...Select between [O] and
external POT at [AT]
(ON=POT, OFF=O)
...Select between [OI] and
external POT at [AT]
(ON=POT, OFF=OI)

00


[O] input active range start
frequency
The output frequency
corresponding to the analog
input range starting point,
range is 0.00 to 400.0(1000.)
*1

0.00
Hz

[O] input active range end
frequency
The output frequency
corresponding to the analog
input range ending point,
range is 0.0 to 400.0(1000.)
*1

0.00
Hz

[O] input active range start
voltage
The starting point (offset) for the
active analog input range,
range is 0. to 100.

0.
%

[O] input active range end
voltage
The ending point (offset) for the
active analog input range,
range is 0. to 100.

100.
%