C O N T E N T S
CHAPTER 1 – WARNINGS AND INSTRUCTIONS ................................................ 1-1
CHAPTER 2 – ELECTROMAGNETICALLY COMPATIBLE
INSTALLATION OF DRIVES AND DRIVE SYSTEMS .......................................... 2-1
INTRODUCTION ............................................................................................................... 2-1
SELECTION OF LINE FILTER TO REDUCE LINE-CONDUCTED INTERFERENCE ...................... 2-2
FILTER INSTALLATION .................................................................................................... 2-3
MINIMIZING RADIATED INTERFERENCE ........................................................................... 2-5
USING EMC COMPLIANT CABLES ................................................................................... 2-6
INSTALLING THE MOTOR CABLE ...................................................................................... 2-7
INSTALLING CONTROL AND SIGNAL LINES ....................................................................... 2-7
SHIELDING AND GROUNDING FOR INSTALLATION IN SWITCH CABINETS ........................... 2-8
CHAPTER 3 – INFLUENCE OF THE MOTOR CABLE LENGTH ....................... 3-1
CHAPTER 4 – FURTHER NOTES.............................................................................. 4-1
INFLUENCE OF GROUND FAULT MONITORING DEVICES .................................................... 4-1
COMPONENTS SUSCEPTIBLE TO INTERFERENCE ............................................................... 4-1
CHAPTER 5 – TECHNICAL SPECIFICATIONS AND DIMENSIONS OF
WJ200 FILTER .............................................................................................................. 5-1
CHAPTER 6 –HARMONICS ...................................................................................... 6-1
To Next Page
Loading...
