Version 1.1, 09/2020. Copyright 2012 Hitron Technologies
15
Version 1.1, 09/2020. Copyright 2020 Hitron Technologies
15
Hitron CODA-551x User’s Guide
Table 2: Hardware Connections
WPS Press this button to begin the WiFi Protected Setup
(WPS) Push-Button Configuration (PBC) procedure.
Press the PBC button on your wireless clients in the
coverage area within two minutes to enable them to join
the wireless network.
The WPS LED displays WiFi Protected Setup
connection status as follows:
Blue, blinking: the WPS connection is processing.
Blue, steady: the WPS connection has been
successful.
Off: WPS is not active.
See WPS on page 80 for more information.
USB Use this port to plug in USB flash disks for mounting and
sharing through the LAN interfaces via the Samba
protocol (network neighborhood).
The CODA-551x supports the following Windows file
systems:
FAT16
FAT32
USB devices must not drain more than 500mA
from the USB port. USB devices requiring
more than 500mA should be provided with
their own power source(s).
RESET Use this button to reboot or reset your CODA-551x to its
factory default settings.
To reboot the CODA-551x, press the button and hold it
for less than five seconds. The CODA-551x restarts,
using your existing settings.
To reset the CODA-551x, press the button and hold it for
five or more seconds. All user-configured settings are
deleted, and the CODA-551x restarts using its factory
default settings.
To Next Page
Loading...
Need help?
General
