Version 1.1, 09/2020. Copyright 2012 Hitron Technologies
67
Version 1.1, 09/2020. Copyright 2020 Hitron Technologies
67
Hitron CODA-551x User’s Guide
4.5.1 Adding or Editing a Port Triggering Rule
To add a new port triggering rule, click Add in the Basic > Port Triggering
screen.
To edit an existing port triggering rule, select the rule’s radio button in the Basic
> Port Triggering screen and click the Edit button.
NOTE: Ensure that Enabled is selected in the Basic > Port Triggering screen in
order to add or edit port triggering rules.
The following screen displays.
Timeout (ms) This displays the time (in milliseconds) after the CODA-
551x opens the Target ports that it should close them.
Twoway Status Usually a port triggering rule works for two IP
addresses; when a rule is enabled, other IPs will also be
allowed to use the rule as a trigger.
Status Use this field to turn the rule On or Off.
Manage Click this to make changes to the rule.
Action Use this to delete the rule.
Add Rule Click this to define a new port forwarding rule. See
Adding or Editing a Port Forwarding Rule on page 63 for
information on the screen that displays.
Save Changes Click this to save your changes to the fields in this
screen.
Help Click this to see information about the fields in this
screen.
Table 17: The Basic: Port Triggering Screen (continued)
To Next Page
Loading...
Need help?
General
