1. Use the Phillips screwdriver in the
16-in-1 tool to loosen the screws on
the bell bracket.
2. Insert the bell bracket into the
corresponding position of the handlebar,
and lock the screw with a Phillips
screwdriver.
5. Pedals Assembly
1. The "L" marked on the pedal shaft is the left
pedal. First, screw the pedal shaft
counterclockwise into the left crank by hand,
and then use a No. 15 open-ended wrench to
tighten it counterclockwise.
2. The "R" marked on the pedal shaft is the right
pedal. First, screw the pedal shaft clockwise into
the right crank by hand, and then use a No. 15
open-ended wrench to tighten it
clockwise.
6. Rear Fender Assembly
Use the No. 4 Allen wrench in the tool to remove the fixing screws and gaskets of the fender sticks
pre-installed on the left and right sides of the frame, and lock the sticks with screws.
Deutsch / English / Français / Español / Italiano / Nederlands / Polski
-58-
To Next Page
