3. Saddle Assembly
1. Open the quick release
handle of the seat tube clamp
according to the direction
shown in the picture.
2. Insert the seat tube
and adjust to the
appropriate height
within the safety scale
on the seat tube.
3. Tighten the seat post clamp
quick release nut, then snap on
the seat post clamp quick
release handle. If the handle is
too tight or too loose, please
adjust the tightness of the quick
release nut.
9. Firmly fasten the quick release handle,
if it is too loose, please tighten the nut on
the opposite side. During this process,
ensure that the front wheel is in the center
of the front fork tube, please release the
handle to adjust the angle of the front
wheel and then buckle it.
4. Reflector Assembly
As shown in the figure, after fixing the reflector in the card slot, tighten the screw with a Phillips
screwdriver in the tool, and install the front and rear wheel reflectors.
Deutsch / English / Français / Español / Italiano / Nederlands / Polski
-57-
To Next Page
