LUCAS NANO 305 FX 1.1
5
Wireless Setup Options with Easy-Click
Mono Cube
No cables needed
Mono System
with S-CONNECT POLE LN
No cables needed
Signal via
Easy-Click
Mono Cube
The mono cube is your simplest option for setting up LUCAS NANO 305 FX.
In this confi guration, the connected pair of satellites is mounted right on
top of the subwoofer. In this setup, the Easy-Click connector also serves to
route the signal between the subwoofer and satellite array.
• To this end, place the subwoofer upright.
• Hold the paired satellites with the speakers facing forward as shown in
the fi gure on the left. Now push on the back of the enclosures, sliding the
pair forward into the guide rail until they click fi rmly into place.
Be advised note that you will not be able to tap the system’s full audio
potential with this setup.
A Mono System with an S-CONNECT POLE LN
Another wireless setup option is the mono system with the optional
S-CONNECT POLE LN, a signal-routing speaker pole. This pole’s base end
screws straight into the M33 pole mount on the subwoofer and its top end
connects to the satellite array via Easy-Click.
Be sure to set the Setup selector to ‘Satellite Array’ when you use these
two wireless setup options (for more on this, see section
●
21
):
Setup
Your LUCAS NANO 305 FX is now ready to go.
For details on setup options (such as stereo and twin stereo systems) as
well as descriptions of the add-ons that are available for these setups, read
Chapter 4 - Setups and Accessories.
• English • Français• Deutsch • Italiano • Español
To Next Page
Loading...
Need help?
General
