HKS EVC - Page 44

Resetallusersetvaluestothedefaultsettingvalues.
７．６．AllResetMode
(１)Pressthevolumeknobformorethan1secondwhilein
theallresetmode.
・Thedigitaldisplay(S)willilluminate[ ].
・TheEVCwillbeepandthedigitaldisplay(L)blinks.
・"ＳＥＬ"willilluminateonthedisplay.
(２)Turnthevolumeknobtoselect"ＹＥＳ"or"ＮＯ".When
theselectionismade,pressthevolumeknobtoset.
・Whenselecting"ＮＯ",resetisNOTdoneandthe
digitaldisplay(L)stopsblinking.
・Whenselecting"ＹＥＳ",allusersetvaluesare
resettodefaultsettingvalues.Followingthis
step,gobacktosection2toredotheintialsetup.
Note
・Usethismodetoresetinitialsettingsorwhenthelockcodeislostorforgotten.
−43−
Note
・Thedefaultvalueis４．５０Ｖ.
(３)Thefullthrottlevoltagevaluecanalsobemanually
inputted.PressButton①andtheiconwillnow
illuminate,indicatingyouareinmanualmode.Turn
thevolumeknobtoselecttheopenvoltageandpress
thevolumeknobtoset.
・TheEVCwillbeepandthevoltagecalueisnowset.
Generallynotneeded,butthesamplingratemodeofthesteppingmotorcanbeadjusted
ifboostvalueisunstableandfluctuatingaboveandbelowthetargetboostvalue.
７．５．SamplingRateSetMode
(１)PressthevolumeknobwhileintheSamplingRateSet
Mode.
・Thedigitaldisplay(S)willilliminate[ ].
・TheEVCwillbeepandthedigitaldisplaywillblink.
・"ＳＥＬ"willilluminateonthedisplay.
(２)Turnthevolumeknobtoselectthesamplingratevalue.
Afterselectionhasbeenmade,pressthevolumeknob
tosetvalue.
・Selectfrom１・２・３・４・５samplingrates.
・Thedefaultsettingissamplingrate４.
www.R33-GTR.org