HMF-IRC Instruction Manual - GB
01-01 HMF TECHNICAL SERVICE DEP.
1
Contents
Chapter Page
1. Introduction 3
2. The Components of the IRC-system 4
3. Description of the system 5
3.1 The IRC-system, general Description 5
3.2 IRC-Remote Control Box 6
3.2.1 General Description of the Remote Control Box 6
3.2.2 Control Levers 7
3.2.2.1 Operating Symbols 7
3.2.2.2 Lever Sequence, 6 Loader Functions 8
3.2.2.3 Lever Sequence, 5 Loader Functions 8
3.2.2.4 Lever Sequence, 4 Loader Functions 9
3.2.2.5 Lever Sequence, 6+2 Loader Functions 9
3.2.3 Press Buttons and Tumbler Switches 10
3.2.3.1 Remote Control of RCL functions 10
3.2.3.2 Engine Throttle Control (Option) 11
3.2.3.3 Engine start-stop (Option) 12
3.2.3.4 Electric Reverser Function, 7 or 8 Loader Functions 13
3.2.3.5 Choice of Engine Revolutions (Option) 15
3.2.4 The Remote Control Box in Stand-by Mode 16
3.3 IRC-Electronic Box 16
3.4 IRC-battery and battery Charger 17
3.4.1 Replacement of the battery 17
3.4.2 Charging of the Battery 18
3.4.3 Good Advice about the Battery 18
3.5 Remote control cable (option) 19
3.6 Transmitter System, frequencies 19
4. Safety Regulations 20
5. Starting Up of the Loader 21
5.1 Starting Up from the Indicator Panel of the RCL 21
5.2 Starting Up of the IRC-System 22
5.3 Starting Up from the IRC-Remote Control Box 22
6. Signalling during Loader Operation 23
7. Emergency Stop during Loader Operation 23
8. Stopping the IRC-system 23
To Next Page
Loading...