HMF HMF-IRC - 1. Introduction

HMF-IRC Instruction Manual - GB
01-01 HMF TECHNICAL SERVICE DEP.
3
1. Introduction
This instruction manual on HMF-IRC radio remote control is meant for the user
of the loader and must be considered as a supplement to:
• the Instruction Manual for the individual Loader Series and
• the RCL Instruction Manual
It is important to read these instruction manuals before starting up and using the
radio remote control. This should give the best starting point for an
unproblematic use of the system.
The designation IRC is short for Integrated Radio Control, which means that the
transmission of data from the radio remote control is an integrated part of the
loader’s RCL safety system.
During loader operation, the IRC-system sends signals to the RCL 5100/5200
controller which monitors which loader functions that are activated.
The RCL safety system is thus monitoring the following parameters:
• The load moment of the loader
• The operation of the loader
• The functional conditions
and stops the loader if critical situations occur.