– 5 –
INSTALLATION
UNPACKING
Immediately after unpacking the dishwasher, check for possible shipping damage. If this
machine is found to be damaged, save the packaging material and contact the carrier
within 15 days of delivery.
Prior to installation, test the electrical service to make sure it agrees with the specications
on the machine data plate; this includes the optional electric booster, if equipped. The
dishwasher data plate is located at the bottom of the front panel.
INSTALLATION CODES
Installation must be in accordance with state and local codes, or in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1 (latest edition) if applicable, and
the National Electrical Code ANSI/NFPA 70 (latest edition). In Canada, the installation
standards are: CAN/CGA B149.1, CAN/CGA B149.2, and CSA C22.2 No.1 (latest editions).
LOCATION
Before nalizing the location, make sure that consideration has been given for the
electrical conduit, water supply, drain connection, gas supply and venting (if applicable),
tabling (if needed), chemical feeder replenishment (if applicable) and adequate clearance
for opening the door.
The dishwasher must be level before any connections are made. Turn the threaded feet
(Fig. 2) as required to level the machine and adjust to the desired height.
The edge of dish table that overhangs the AM15 wash tank should be turned down
and tted over the top of the dishwasher tank (Fig. 3). Apply an NSF approved sealant
between the overhang of the dish table and the inner wall of the wash tank to prevent
leakage (Fig. 3). Fasten the dish tables to the inner wall of the wash tank with non-rusting
truss head screws or rivets (Fig. 3).
For straight-through installations, clearance at the front and 15 inches out from the
dishwasher at the right side by 27 inches above the nished oor must be provided for
servicing.
Fig. 2
Fig. 3
WASH TANK
DISH TABLE
DISH TABLE
STRAIGHT-THROUGH OPERATION SHOWN
INNER WALL OF
WASH TANK
SEALANT
NUT
DISH TABLE
MAC HI N E SC RE W
OR RIVET
To Next Page
Loading...
