INSTRUCTION MANUAL FOR DISHWASHERS
Page 6 of 15
GB
4.5 Washing cycle
• Check to make sure there is d
aid. Information about the type of products to be
used and the dosage (automatic or manual) is
found in the chapter “Adjustment and controls”.
•
Use a suitable rack, filling it without overloading it
and without placing the dishes one on t
other. Always clean off the dishes beforehand
and do not load dishes with dry or solid residue on
them.
• Place the empty containers upside-
rack. Put the plates and similar kitchenware into
the special inclined rack, with the internal
facing upwards. Put the mixed silverware into the
special basket with the handles facing downwards.
• Wash items intended for dishwasher use only.
•
It is advisable to wash the dishes immediately after
use, in order to prevent any residuals from
hardening and sticking on them.
For versions with rotating basket:
If possible, run the cycle only with the basket full,
evenly distributing the dishes.
•
Place the lightest dishes near the middle of the
rack, and the heaviest ones near the outside.
• Place the
smallest dishes near the middle of the
rack, and the largest ones near the outside.
• Load the rack into the machine and close the door.
• For versions with rotating basket,
make sure the basket turns freely, lightly spinning it
clockwise, then close the door and start the cycle.
• To avoid breakage, use only dishes that are intact and guaranteed for machine washing.
•
Do not place silver and stainless steel silverware in the same silverware basket. Burnishing of
the silver and probable corrosion of the steel would result from it.
Among the available cycles, select a washing cycle
suitable for the items to be washed, by repeatedly
pressing the cyclic program button, shown here, until
the corresponding warning light turn on.
To start the cycle, press the start / start cycle button
shown at the side. The corresponding cycle indicator
After the washing stage, the rinsing and drain stages
start, and the cycle comes to an end. The indicator
lamp goes back to being on and not blinking.
•
If the door is accidentally opened during the cycle, the machine stops automatically. All you have
to do is close the door again in order to resume from the point it was interrupted.
• In order to get rapid drying, immedia
tely remove the rack from the machine at the end of the
cycle.
• If you want to stop the washing cycle in advance, press the on / off button.
•
If the washing solution should prove too dirty or if you notice residues of grime on the
tank filter, perform the routine maintenance as described in the chapter “Maintenance”.
To Next Page
Loading...
Need help?
General
