INSTRUCTION MANUAL FOR DISHWASHERS
Page 5 of 15
GB
Chap 4 MACHINE USE
4.1 Control panel and legend
Indicator lamp
blinking
START
The following images, describing the operation of
the appliance refer to the control panels of
Open the water network tap and switch on the main
power switch.
2. Check the presence of the overflow, if necessary.
3.
Press the on / off button as shown at the side (the
corresponding indicator lamp turns on).
4.3 Filling
•
Whenever the first filling is carried out with the boiler empty, the Quick ready
function must not be activated (as per factory settings).
• On CRP models only, the Quick ready function must always be active
when the boiler is empty (see chapter “Adjustments and Settings”).
If the discharge pump or water softener is present,
to fill the machine select a wash cycle by pressing
the program cycle button (the correspond
indicator lamp turns on) and press the start button
as shown at the side. Otherwise, filling starts when
With break tank present and boiler
empty, wait about 15 seconds after the starting
stage.
• The machine ready indicator lamp may bli
off during the filling stage.
•
The indicator lamp remains on and green when the
machine is ready (full tank and tank and boiler
When the resistances are heating, a green dot appears
display next to the temperature indicator. When
set temperatures (approx. 55°C for the
tank and approx. 85°C for the boiler) are reached, the
corresponding dot turns off.
To Next Page
Loading...
Need help?
General
