Hobart CLF26D-10 - 9.5 Removing the Rinse Agent Dispenser Regulator

INSTRUCTION MANUAL FOR DISHWASHERS
Page 15 of 15
GB
9.5 Removing the Rinse Agent Dispenser Regulato
r
The internal components (boot, …) are subject to wear, therefore they must be periodically replaced.
In case of intervention on the rinse aid dispenser, carry out the following steps:
1) Drain the appliance as
described in “Discharging
the appliance”.
2) Loosen the four
screws holding the
dispenser.
3) Replace any faulty
components.
4) Refit the dispenser
correctly centring the
rubber bellow.