➀
Machine ON / OFF
Pushing this button switches the machine on.
As soon as the machine is ready for operation, the wash cycle is started by
pushing this button also.
By pushing and holding (3 seconds) this button, the drain and self cleaning
cycle starts. At the end of the cycle, the machine switches off automatically.
After switch off, the machine is not voltage free!
Furthermore the button illuminates to indicate the mode of the machine:
GREEN
GREEN
BLUE
BLUE
RED
GREEN/RED
(flashing)
(permanent)
(permanent)
(flashing)
(permanent)
(alternate flashing)
= Machine fills and starts heating
= Machine is ready for operation
= Wash cycle is running
= Machine draining / switch-off
= Failure indication (see chapter 8)
= Failure indication (see chapter 8)
➁
Program button
By pushing this button, it is possible to select between different preset
programs, according to the model and equipment.
The program no. (e.g. P02) will be shown in the Display
➄
.
➂
Stop button
In case of operating error or faults, it is possible to switch-off the
machine immediately without the drain cycle, by pushing this button.
After switch off, the machine is not voltage free!
➃
Display e.g. temperature indication Wash (°C) (see chapter 7).
➄
Display e.g. temperature indication Rinse (°C) (see chapter 7).
➅
Salt required
Indicating the need for regeneration salt to be added.
(Only with built-in softener.)
➆
Service indicator
Indicating, that the machine has a fault (see chapter 8).
To Next Page
Loading...
Need help?
General
