5. Exterior Structure
43
Key assignments may vary, depending on the model.
Continue pressing the switch until the step has completely
folded in or out.
If, due to dirt or frost, the entrance step does not function
properly or at all, the hinges must be cleaned or defrosted.
To open
• Press the switch
k
in the entrance area.
The entrance step will be extended automatically.
To close
• Press the switch
l
in the entrance area.
The entrance step will be retracted automatically.
2
3
5.4 Levelling supports *
The levelling supports are located in the rear area by the
frame extension.
Swinging out the levelling supports
• Place the crank on the hexagon head
j
.
• Turn the crank to move the support to a vertical position.
• If necessary, secure the foot
k
to prevent it from sinking
into the ground and place it on a rm base.
• If the levelling support is in a vertical position, the support
foot will extend telescopically.
• Use the crank to level the levelling supports until the vehi-
cle stands level.
2
1
2
Levelling supports, folded in
Retracted entrance step Switch for step tread
To Next Page
Loading...
