12
HOBIE 15 CLUB
Shackle the two jib clew blocks to the clew of
the jib. Thread the jib sheet line through the
clew and sheet blocks (see explanations below)
as per photograph. The jib can now be furled by
pulling on the furler line and cleating it off on
the front beam.
RAISING THE MAST
Now the rigging can be tensioned. One person can pull down on
the trapeze wires while the other person moves the shrouds into
a lower position in the stay adjuster. Ensure both sides are
equal. Position the stay adjuster covers over the adjusters
and twist toggles.
Jib sheet system
: Tie one end of the jib sheet
around the clevis pin in one of the jib sheet
blocks on the front crossbar. Lead it through the
clew block and back through the cam cleat. Lead
the free end of the jib sheet to the opposite jib
sheet block. Route it identically to the first side,
but in reverse order.
5
7
6
To Next Page
Loading...
Need help?
General
