HOBIE 15 CLUB
9
MAST SET UP
Assemble the stay adjusters with twist toggles, clevis pins and split
rings. Attach them to the anchor bar pins. Ensure that the stay
adjuster points fore and aft - as per photograph.
1
Attach the two bridles to the jib furler. Now is a
good time to roll some line onto the furler drum.
Roll in a clockwise direction. leave enough line to
reach the furler cleat on the front crossbar.
NB: Ensure that the hole in the furler housing
points toward the front crossbar.
2
Tie the main halyard line to the
thimble at the end of the main
halyard wire. Take both ends to the
base of the mast and secure to
halyard cleat.
3
Using the 8mm bow shackle provided, attach the
wires to the mast tang as shown in the
photograph. Tighten the shackle securely and
check tightness on a regular basis.
4
Estrope
T
r
a
p
e
ze
(
2
)
S
h
r
o
u
d
To Next Page
Loading...
Need help?
General
