14
HOBIE 15 CLUB Main traveller
Take the traveller car CCT and dismount it out
by removing the pin and the split ring. Slide
the bearing cylinger out by pressing the end
of the plastic part.
Take the cylinder out of the upper part.
Split the plastic slide in two parts and insert
each one in the track of the rear
crossbar.Slide them one over the other until
they fit together
Reassemble the traveller car in a reverse
manner, i.e. : fit in the upper part, slide the
cylinder and place the pin and the split ring.
To Next Page
Loading...
Need help?
General
