Why does my Holzstar TKS 316 E Saw engine get hot?
Your Holzstar Saw engine may be overheating due to a short circuit in the engine or an overload. If there is a short circuit, disconnect the power and have it repaired by qualified personnel. If it is an overload, ensure the saw blade is appropriate and sharp enough for the material you're cutting. Also, allow the engine to cool down by taking a break.
What to do if my Holzstar TKS 316 E Saw workpiece is knocked back by the saw blade?
If the workpiece is knocked back by the saw blade on your Holzstar Saw, it could be due to several reasons. First, ensure the stops are correctly aligned. Next, check that the disconnecting blade is aligned with the saw blade. Finally, inspect the saw blade itself and replace it if it's defective.
What to do if my Holzstar TKS 316 E Saw vibrates and the saw blade strikes?
If your Holzstar Saw vibrates and the saw blade strikes, there could be a few reasons. First, verify that the saw blade conforms to the specifications in the technical data to ensure it's suitable for installation. Next, check if the saw blade is sufficiently secured and tighten the fixing screw if needed. Finally, inspect the saw blade for any mechanical damage and replace it if necessary.
How to fix no clean 45° or 90° cuts on a Holzstar TKS 316 E Saw?
If you're not getting clean 45° or 90° cuts with your Holzstar Saw, it might be because the stops are not aligned correctly. Check the saw blade with a standard angle and align the stops. Another possible cause is that the angle display is not set correctly; check the saw blade with a standard angle and adjust the angle display.
Why Holzstar TKS 316 E Saw engine does not start?
If your Holzstar Saw engine isn't starting, it could be due to a few reasons: there may be no mains voltage, the connection cable could be defective, or the motor itself might be defective. In any of these cases, have the power connection checked by qualified personnel.
Why is the saw blade speed too low on my Holzstar TKS 316 E?
A low saw blade speed on your Holzstar Saw could be due to a defective engine or too low mains voltage. Have the engine and/or the mains voltage checked by qualified personnel.
What to do if the engine is running but the saw blade is not turning on my Holzstar TKS 316 E?
If the engine of your Holzstar Saw is running but the saw blade isn't turning, it's likely that the drive shaft is defective. Replace the drive shaft.
Details required PPE for safe operation and tasks.
Describes essential safety features like riving knife and blade guard.
Provides overarching safety guidelines for operation and environment.
Specifies conditions for a safe and effective workspace.
Steps to assemble the main chassis and attach legs.
Instructions for attaching and adjusting the rip fence.
Adjusting the saw blade height and angle.
How to attach the protective saw blade guard.
Steps for assembling and mounting the sliding carriage.
Adjusting the sliding table for parallel and height alignment.
Key points for safe and correct electrical hookup.
Essential checks before operating the machine.
Adjusting the saw blade angle for bevel cuts.
Adjusting the saw blade's cutting depth.
Method for making longitudinal cuts on wide materials.
Technique for making longitudinal cuts on narrow materials.
Method for making transverse cuts on narrow materials.
Table of common problems and their resolutions.
General| Blade Diameter | 315 mm |
|---|---|
| Table Size | 800 x 550 mm |
| Voltage | 230 V |
| Saw Blade Bore | 30 mm |
| Cutting Speed/No-Load Speed | 2800 rpm |
| Table Height | 850 mm |
| Extraction Port Diameter | 100 mm |
| Motor power S1 | 2.2 kW |
To Next Page
