What to do if my Holzstar TKS 254 E workpiece is knocked back by the saw blade?
If the workpiece is knocked back by the saw blade, it could be due to several reasons. First, ensure that the stops are correctly aligned. Second, check if the riving knife is aligned with the saw blade and adjust if necessary. Finally, inspect the saw blade for any defects and replace it if needed.
Why is my Holzstar TKS 254 E Saw engine getting hot?
If the engine is getting hot, it could be due to a motor short circuit. In this case, disconnect the power plug and have the machine repaired by qualified personnel. Alternatively, it might be due to an overload of the engine. Check that the saw blade is suitable for the material you are cutting and that it is sufficiently sharp. Also, take a break to allow the engine to cool down.
What to do if Holzstar Saw vibrates and saw blade strikes?
If the saw vibrates and the saw blade strikes, first check if the saw blade matches the specifications for installation. Second, ensure the saw blade is sufficiently secured by tightening the fixing screw. Lastly, inspect the saw blade for mechanical damage and replace it if necessary.
How to fix no clean 45° or 90° cuts with my Holzstar TKS 254 E?
If you're not getting clean 45° or 90° cuts, the stops may not be aligned correctly. Check the saw blade with a standard angle and align the stops. Also, the angle display might not be set correctly, so check the saw blade with a standard angle and adjust the angle display.
Why is the saw blade speed too low on my Holzstar TKS 254 E Saw?
A low saw blade speed could be due to a defective engine. Have the engine checked by qualified personnel. It could also be caused by too low mains voltage, in which case you should have the mains voltage checked by qualified personnel.
What to do if the Holzstar Saw engine is running, but the saw blade is not turning?
If the engine is running but the saw blade isn't turning, the drive shaft may be defective. Replace the drive shaft.
General| Type | Table Saw |
|---|---|
| Blade Diameter | 254 mm |
| Max Cutting Height at 90° | 80 mm |
| Max Cutting Height at 45° | 55 mm |
| Voltage | 230 V |
| Saw Blade Bore | 30 mm |
| Motor Power | 2000 W |
To Next Page
