6 TKS Serie | Version 1.04
Safety
Push stick
The push stick serves as an extension of the hand and
protects against accidental contact with the saw blade.
The push stick must always be used if the distance bet-
ween the stop profile and the saw blade is less than or
equal to 120 mm.
2.7 General safety instructions
Please note the following:
- Use the guards and secure them securely. Never work
without guards and get them working.
- Always keep the table saw and its working environment
clean. Ensure adequate lighting and ventilation.
- The table saw must not be modified in its design and
should not be used for purposes other than those fore-
seen by the manufacturer.
- Never work under the influence of concentration-distur-
bing illnesses, fatigue, drugs, alcohol or medicines.
- Keep children and not with the table saw.Familiar
people away from their working environment.
- Do not pull on the mains lead to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
edges.
- Eliminate disturbances that affect safety immediately.
- Before each use, make sure that no parts of the table
saw are damaged.
- Damaged parts must be replaced immediately to avoid
danger sources.
- Do not overload the table saw! You work better and
safer in the specified performance range.
- Do not wear watches, rings or other jewelry and roll
back the sleeves before working with the table saw.
- Do not use the pump in hazardous areas or near flam-
mable liquids and gases.
- Do not touch the power plug with wet hands.
- After switching off the working machine, the extraction
system will run for another 3-4 seconds and then switch
off automatically. The residual dust is sucked out, as
required in the Hazardous Substances Ordinance. This
saves electricity and reduces noise. The extraction sy-
stem runs only while the machine is being operated.
- For work in the commercial sector, a suction system
must be used for suction.
- Do not switch off or remove the extraction system or
dust extractor while the machine is running.
- Keep the floor around the machine clean and free of
scrap, sawdust or oil to avoid the risk of tripping or slip-
ping.
- Only use original spare parts and accessories to avoid
possible risks and risks of accidents.
- Basically, the workpieces to be machined must be free
of foreign bodies such as nails or screws.
- Should it be necessary to work next to the machine, the
use of ear protection (headphones,Earmuffs, etc.) re-
quired.
IMPORTANT!!
Do not disassemble protective devices on the table
saw. Remember the position (location) of the emer-
gency stop button so that you can use it immediately
at any time.
DANGER!
The machine may only be used, maintained or
repaired by persons who are familiar with it and have
been informed of the dangers. Unauthorized modifi-
cations to the machine exclude liability of the manu-
facturer for resulting damages
IMPORTANT!!
Do not wear a long piece of clothing and use a hair
protector.
DANGER!
Check the saw blade for cracks or missing teeth. Do
not use cracked or dull blades. Make sure the blade
is firmly seated on the shaft.
DANGER!
Do not reach near the blade to remove any parts or
scrap while the saw blade is running.
DANGER!
Always use the blade guard and push stick while
working on the table saw.
DANGER!
Never clean the table saw during operation.
ATTENTION!
When working with wood always wear a dust mask to
avoid health risks caused by wood dust.
To Next Page
Loading...
