Safety
TKS Serie | Version 1.04 5
- Operators must make sure that all persons hand-ling
the machine have read and understood these opera-
ting instructions. Operators must also regu-larly train
staff and notify of the hazards.
- Operators shall provide staff with the required pro-
tective equipment and wearing the required pro-
tective equipment shall be mandatory.
Operators shall also be responsible for maintaining the
machine in a technically perfect condition.
For this reason, the following shall apply:
- Operators shall make sure that the maintenance in-
tervals described in these operating instructions
are complied with.
- Operators shall regularly check that the safety
equipment is fully functional and complete.
2.4 Operating staff qualification
The different tasks described in these operating instruc-
tions require different levels of skills in terms of the qua-
lifications of operating staff working with the machine.
Exclusively persons of whom it can be expected that they
reliably complete assigned tasks shall be autho-ri-sed to
carry out any tasks. Persons whose reactions have been
impaired shall not be authorized, e.g. drug users, users
under the influence of alcohol or medication.
These operating instructions specify the following per-
sonal qualifications for the different tasks:
Operating staff:
Operating staff has undergone an induction by the ope-
rator about the entrusted tasks and potential hazards re-
sulting from improper behaviour. Tasks which go bey-
ond normal operation may only be carried out by the
operator if they are listed in the operation manual and
the operator has made him/herself familiar with them.
Specialist staff:
As a result of specialist training, expertise, experience
and skills in terms of the relevant standards and regula-
tions, specialist staff is able to complete the tasks they
are entrusted with and independently identify hazards
and avert risks.
Manufacturer:
Certain work must be carried out by manufacturer spe-
cialist staff only. Other staff is not permitted to carry out
this work. Contact our customer service to have the work
carried out.
2.5 Safety labels on the Circular Table Saw
The following safety labels and instructions are attached
to the Circular Table Saw (Fig. 1) and must be obser-
ved.
Fig. 1: Safety labels
If safety labels on the machine are damaged or missing,
this can cause errors, personal injury and material da-
mage. The safety symbols attached to the machine must
not be removed. Damaged safety symbols must be re-
placed immediately.
As soon as the signs are not clearly visible and com-pre-
hensible at first glance, the machine must be stop-ped
until new signs have been attached.
2.6 Safety devices
Chip guard
The chip guard protects against accidental contact with
the saw blade and flying chips. The chipbreaker must al-
ways be mounted during operation.
WARNING!
Riskfr omin adequatelyq ualified
persons!
Inadequately qualified persons are unable to assess
the risks when handling the machine, thus putting
themselves and others at risk of severe injuries.
- All work must be carried out by qualified persons
only.
- Keep inadequately qualified persons and children
away from the work area.
WARNING!
Read all safety instructions and instructions.
Failure to follow safety instructions and
instructions may result in electric shock, fire and
/ or serious injury.Retain all safety instructions
and instructions for the future.
To Next Page
Loading...
