Why doesn't the engine of my Holzstar FKS 315-2000 E start?
If the Holzstar Saw engine doesn't start, the issue might be due to no mains voltage or a defective connection cable. Have the power connection checked by qualified personnel.
What to do if the engine of my Holzstar FKS 315-2000 E is getting hot?
If the engine of your Holzstar Saw is getting hot, it could be due to an engine short circuit or an overload. In case of a short circuit, disconnect the power plug and have the machine repaired by qualified personnel. If it is an overload, check that the saw blade is suitable for the material and sufficiently sharp, then take a break to let the engine cool down.
Why is the workpiece knocked back by the saw blade on my Holzstar Saw?
If the workpiece is knocked back by the saw blade of your Holzstar Saw, it may be due to stops not aligned correctly, the disconnect blade not aligned with saw blade or a defective saw blade. Align the stops, align the cutting blade with the saw blade, or replace the saw blade.
How to fix a Holzstar FKS 315-2000 E Saw that vibrates and the saw blade strikes?
If your Holzstar Saw vibrates and the saw blade strikes, the saw blade may not match the specification, not be sufficiently secured, or be defective. Check the saw blade based on the specifications in the technical data to see if it is suitable for installation. Tighten the fixing screw. Check the saw blade for mechanical damage and replace it if necessary.
Why is the saw blade speed too low on my Holzstar FKS 315-2000 E Saw?
If the saw blade speed of your Holzstar Saw is too low, the engine may be defective or the mains voltage may be too low. Have the engine or the mains voltage checked by qualified personnel.
How to get clean 45 or 90 degree cuts with my Holzstar FKS 315-2000 E?
If your Holzstar Saw is not making clean 45° or 90° cuts, it could be because the stops are not aligned correctly or the angle display is not set correctly. Check the saw blade with a standard angle and align the stops, or check the saw blade with a standard angle and adjust the angle display.
What to do if saw blade of my Holzstar FKS 315-2000 E does not start or stops under load?
If the saw blade of your Holzstar Saw does not start or stops under load, the drive belt may not be sufficiently tensioned. Check the belt tension.
Why is my Holzstar FKS 315-2000 E Saw blade not turning even though the engine is running?
If the engine of your Holzstar Saw is running but the saw blade isn't turning, the drive belt might be torn. Replace the drive belt.
Why does the saw blade rotate unevenly under load on my Holzstar FKS 315-2000 E?
If the saw blade of your Holzstar Saw rotates unevenly under load, the drive belt may not be sufficiently tensioned. Check the belt tension.
What causes the braking time to be longer than 10 seconds on my Holzstar FKS 315-2000 E Saw?
If the braking time of the Holzstar Saw is longer than 10 seconds, it could be a loose belt. Tighten the belt or replace it if worn.
General| Blade Diameter | 315 mm |
|---|---|
| Cutting Height 90° | 90 mm |
| Table Size | 800 x 550 mm |
| Voltage | 400 V |
| Saw Blade Bore | 30 mm |
| Sliding Table | Yes |
| Table Extension | Yes |
| Table Width Extension | Yes |
| Extraction Port Diameter | 100 mm |
| Cutting Speed | 50 m/s |
To Next Page
