Safety
TKS 316 E | Version 1.02 5
- The operator must inform himself about the appli-
cable occupational health and safety regulations
and determine additional hazards in a hazard as-
sessment which are caused by the special working
conditions at the place of use of the machine.
These must be implemented in the form of opera-
ting instructions for the operation of the machine.
- During the entire period of use of the machine, the
operator must check whether the operating instruc-
tions issued by him correspond to the current state
of the rules and regulations and, if necessary, ad-
apt them.
- The operator must clearly regulate and define the
responsibilities for installation, operation, trouble-
shooting, maintenance and cleaning.
- The operator must ensure that all persons hand-
ling the machine have read and understood these
in-structions. In addition, he must train the person-
nel at regular intervals and inform them about the
dan-gers.
- The operator must provide the personnel with the
necessary protective equipment and instruct them
to wear the required protective equipment in a bin-
ding manner.
Furthermore, the operator is responsible for ensuring
that the machine is always in perfect technical condition.
The following therefore applies:
- The operator must ensure that the maintenance in-
tervals described in these instructions are obser-
ved.
- The operator must have all safety devices regu-
larly checked for operability and completeness.
2.4 Personal requirements
Qualifications
The various tasks described in this manual place diffe-
rent demands on the qualifications of the persons entru-
sted with these tasks.
Only persons reliable working procedures can be ex-
pected from, are allowed to perform all works. Persons
the responsi-veness of which is affected by e. g. drugs,
alcohol or medica-tion, are not allowed to work with the
machine.
The qualifications of the personnel for the different tasks
are mentioned below:
Operator
The operator is instructed by the operating company
about the assigned tasks and possible risks in case of
improper behaviour. Any tasks which need to be perfor-
med beyond the operation if it is indicated in these in-
structions and if the operating company expressively
commissioned the operator.
Qualified personnel
Due to their professional training, knowledge and experi-
ence as well as their knowledge of relevant regulations
the specialist staff is able to perform the assigned tasks
and to recognise and avoid any possible dangers them-
selves.
Manufacturer
Certain works may only be performed by specialist per-
sonnel of the manufacturer. Other personnel is not au-
thorized to perform these works. Please contact our cus-
tomer service for the execution of all arising work.
WARNING!
Danger in case of insufficient quali-
fication of the staff!
Insufficiently qualified persons cannot estimate the
risks while using the table saw and expose themsel-
ves and others to the danger of severe or lethal inju-
ries.
- Have all works only performed by qualified persons.
- Keep insufficiently qualified persons out of the wor-
king area.
To Next Page
Loading...
