40
Hazard information
The device is part of the building installation. Ob-
serve the relevant national standards and direc-
tives during planning and set-up. The device is
intended for operation within the Homematic IP
Wired bus only. The Homematic IP Wired bus is a
SELV power circuit. Common cable routing of
power supply and the Homematic IP Wired bus in
installation or junction boxes is not permitted.
The required isolation for power supply of the
building installation to the Homematic IP Wired
bus must be observed at all times. Non-compli-
ance with the installation instructions can cause
fire or introduce other hazards.
The device may only be used for fixed installa-
tions. The device must be securely attached with-
in a fixed installation.
Using the device for any purpose other than that
described in this operating manual does not fall
within the scope of intended use and shall invali-
date any warranty or liability.
The device may only be operated within domes-
tic environment, in business and trade areas as
well as in small enterprises.
To Next Page
Loading...
Need help?
General
