49
Start-up
mounting plate to the side (figure 6).
• Connect the bus line to the bus connecting
terminals (see figure 7+8). To connect and loosen
the single wires, press the orange clamp using a
small screwdriver.
• Put the green push-in terminal back into the
mounting plate (see figure 8).
• Place the mounting plate on the brackets (H)
of the installation adapter and then fasten them
using the screws (3.2 x 15 mm) supplied (see
figure 9).
• Place the electronic unit of presence sensor into
the installation adapter by fully snapping the con-
nection pins into the appropriate bracket of the
mounting plate (see figure 10).
• Switch the Homematic IP Wired bus on again.
6.3 Installation on a flush-mounted box
For installation on a flush-mounting box, please proceed
as follows:
• Disconnect the corresponding line of the incom-
ing Homematic IP wired bus.
• To facilitate the connection of the bus line to the
terminals of the presence sensor, remove the
green push-in terminal from the device. Press the
latch on the back of the mounting plate next to
the lock symbol and slide the clamp out of the
mounting plate to the side (figure 6).
To Next Page
Loading...
