45
Start-up
6 Start-up
6.1 Installation instructions
Since the bus is powered by the Homematic IP
Wired Access Point (HmIPW-DRAP), you must
first set-up a Homematic IP Wired Access Point
(HmIPW-DRAP) to enable power supply for the
device.
Before installation, please note the device num-
ber (SGTIN) labelled on the device as well as the
exact application purpose in order to make later
allocation easier. You can also find the device
number on the QR code sticker supplied.
Please note the insulation stripping length of the
conductor to be connected, indicated on the de
-
vice.
Please observe the hazard information in section
“2 Hazard information” on page 38 during in
-
stallation.
Please note! Only to be installed by persons with
the relevant electro-technical knowledge and
experience!*
To Next Page
Loading...
Need help?
General
