The outside air intakes for the
climate control system are at the
base of the windscreen. Keep this
area clear of leaves and other debris.
Switch to recirculation mode when
driving through dusty or smoky
conditions, then return to f resh air
mode.
Thesystemshouldbeleftinfresh
air mode under almost all conditions.
Keeping the system in recirculation
mode can cause the windows to fog
up.
Use the MODE button to select the
vents t he air flows from. Some air
will flow from the dashboard corner
vents in all modes.
Each time you press the MODE
button, the display shows the mode
selected.
This button directs the main airf low
to the windscreen f or f aster
defrosting. It also overrides any
mode selection you may have made.
When you select , the system
automatically switches to fresh air
mode. For faster defrosting,
manually set the fan speed to high.
Y ou can also increase airflow to the
windscreen by closing the side vents
on the dashboard.
When you turn off by
pressing the button again, the
system returns to its former settings.
For your safety, make sure you have
a clear view through all the windows
before driving.
Airflow is divided between
the floor and corner vents, and the
demister vents at the base of the
windscreen.
Air flows from the floor and
corner vents.
Airflow is divided between
the vents in the dashboard and the
floor vents.
Air f lows f rom the centre
and corner vents in the dashboard.
Vents and Heating
Features
Mode Button Windscreen Demister Button
192
06/12/06 10:53:50 32SMR600_195
To Next Page
Loading...
