Honda BF2A - Outboard Motor Attachment

INSTALLATION
OUTBOARD MOTOR ATTACHMENT
Attach the stern bracket to the tran-
som and tighten the clamp screws.
l Before operating the boat, check
the tightness of the clamp screws.
l Tie a rope through the hole in the
stern bracket and secure the other
end of the rope to the boat. This
will prevent accidental loss of the
motor.
SAFETY ROPE
CLAMP SCREW
MOTOR ANGLE FOR CRUISING
Adjust the motor so the propeller shaft is parallel with the water surface.
INCORRECT
CAUSES BOAT TO “SGUAT”
0.K
4
CORRECT
GIVES MAXIMUM PERFORMANCE
INCORRECT
CAUSES BOAT TO “PLOW”