Honda BF2A - Safety Inspection Procedures; Maintenance Inspection Procedures

BEFORE OPERATION
Safety Inspection
l Look around for signs of oil or gasoline leaks. Make sure the fuel filler cap
and cap gasket are in good condition. Wipe up any spills before starting the
engine.
l Check the stern bracket to be sure the outboard motor is securely installed.
l Check that all controls are operating properly.
l Replace any damaged parts.
l Check that all fasteners are in place and securely tightened.
Maintenance Inspection
l Check the engine oil level (see page 41). Running the engine with a low oil
level can cause engine damage.
l Check to be sure the propeller is undamaged, and the retaining nut is
secured with a cotter pin (see page 50).
l Check that the anode is securely attached to the anticavitation plate and is
not excessively worn (see page 49). The anode helps to protect the
outboard motor from corrosion.
l Make sure the tool kit and spare parts are onboard (see page 36).
Replace any missing items.
l Check the fuel level in the fuel tank (see page 38).
21