BF40A-BF50A
[l] STARTER MAGNETIC
SWITCH GROUND
TERMINAL
the engine as shown.
PI
BATTERY GROUND TERMINAL
Install the battery ground terminal
to
the starter motor as shown.
I\
\\
\
and STARTER MOTOR CABLE
\'
[3] MAIN WIRE HARNESS
GROUND TERMINAL
Install the ground terminal
to
the
engine as shown.
[4]
WIRE HARNESS CLIP
[81
REGULATOWRECTIFIER
open end facing up as
ND TERMINAL
[5] WIRE HARNESS CLIP
r71
BATTERY POSITIVE CABLE
Install the battery positive cable and power trimhilt relay
wire (power trimhilt type only), and starter motor cable as
shown.
PI-1
BATTERY
POSITIVE
CABLE
[TI-3
POWER TRIM/TILT
POWER SUPPLY WI
(Power trimhilt
r71-2
,STARTER
MOTOR
CABLE
\
[6] WIRE HARNESS CLIP
mal valve heater wire,
power trim/tilt relay wire,
regulatorhectifier ground
wire, and starter magnetic
switch wire) with the open
end facing up as shown.
Clamp the wires (main wire
harness, power trimhilt relay
wire, regulatorhectifier wire,
neutral switch wire, and
starter magnetic switch wire)
with the open end facing up
as shown.
24
8
To Next Page
Loading...
