64
SERVICING YOUR OUTBOARD MOTOR
2. Remove the oil filler cap, and
remove the engine oil drain bolt
and washer.
3. Allow the used oil to drain
completely, then reinstall the
engine oil drain bolt and a new
washer, and tighten it securely.
ENGINE OIL DRAIN BOLT
TORQUE:
24 lbf·ft (33 N·m, 3.4 kgf·m)
Improper disposal of engine oil can
be harmful to the environment. If
you change your own oil, please
dispose of the used oil properly. Put
it in a sealed container, and take it
to a recycling center. Do not
discard it in a trash bin, dump it on
the ground, or pour it down a
drain.
4. With the outboard motor in a
vertical position, fill to the upper
limit mark on the dipstick with the
recommended oil.
5. Install the oil filler cap and tighten
it securely.
6. Install the engine cover (p. 61), and
lock it in place by locking the
engine cover latch.
DIPSTICK
UPPER LIMIT
18 US oz
(0.55 L, 0.48 Imp qt)
LOWER LIMIT
15 US oz (0.45 ℓ, 0.40 Imp qt)
31ZVC6000.book Page 64 Tuesday, June 28, 2016 1:09 PM
To Next Page
Loading...
