Honda PCX150 2013 User Manual

LIGHTS/METERS/SWITCHES
SIGNAL
MO EL)
{'13
INSPECTION
Before performing the inspection, check the following:
- Battery condition
- Burned out bulb or non-specified wattage
- Blown WINKER, STOP HORN fuse (10
A)
- Turn signal switch function
- Loose connector
- Horn operation
Remove the front meter panel (page 2-7).
Disconnect the turn signal light relay 2P connector [1]
from the relay [2].
Short the turn signal light relay 2P connector terminals
of the wire harness side with a jumper wire.
CONNECTION: Black/brown - Gray
Turn the ignition switch
ON
and
engine stop switch
"0".
Check the turn signal light
by
turning the switch
ON.
If the light comes on, the turn signal light relay
is
faulty
or connector has poor connection.
If the light does not come
on,
the wire harness
is
broken.
LED CONTR
MOD L)
UNIT
'13
21-28
REMOVAL/INSTALLATION
Remove the front meter panel (page 2-7).
Remove the LED control unit
[1]
with the rubber holder
[2].
Disconnect the 20P (Gray) connector [3].
Remove the LED control unit from the rubber holder.
Installation
is
in
the reverse order of removal.

Honda PCX150 2013 Specifications

General

Displacement	153 cc
Bore x Stroke	58.0 mm x 57.9 mm
Compression Ratio	10.6:1
Transmission	Automatic V-Matic belt drive
Front Tire	90/90-14
Rear Tire	100/90-14
Wheelbase	51.8 inches
Fuel System	PGM-FI
Ignition	Fully transistorized
Front Suspension	Telescopic fork
Rear Suspension	Unit swing
Front Brake	Hydraulic disc
Rear Brake	Drum
Fuel Capacity	2.1 gallons
Engine Type	Liquid-cooled, 4-stroke, SOHC, single-cylinder
Curb Weight	286 lbs (130 kg)