Honda Remote Engine Starter System - Stopping the Engine Remotely

© 2012 American Honda Motor Co., Inc. - All Rights Reserved. 19
Stopping the Engine
1. Push the engine button on the transmitter for
1 second or less, then push the unlock/stop button
within 2 seconds.
2. The transmitter emits a beep, and sends a signal to
stop the engine. When the engine stops, the
transmitter emits a beep, and the OFF indicator is
shown on the display.
NOTE
• When the RF signal from the
transmitter does not carry to the
receiver, the transmitter emits three
short buzzer sounds and reception
failure indicator is shown on the
display.
• The engine cannot be stopped with
the transmitter when it was started using the ignition
key.
• In some cases the remote transmission range can be
longer than the reception range. Therefore the engine
can be started/stopped, and the remote status may
not be displayed.
B127550H
ENGINE-OFF
INDICATOR
UNLOCK/
STOP
BUTTON
ENGINE
BUTTON
RECEPTION
FAILURE
INDICATOR
B127540H