i
Chapter 1 - Getting Started
About This Manual .......................................................1-1
Unpacking the Imager..................................................1-1
3800g Models ..............................................................1-1
Connecting the Imager with USB.................................1-2
USB PC or Macintosh Keyboard............................1-2
IBM SurePos..........................................................1-3
USB HID.................................................................1-3
USB Com Port Emulation.......................................1-3
Plug and Play...............................................................1-4
Connecting the Imager When Powered by Host
(Keyboard Wedge) ....................................................1-4
Keyboard Wedge Connection ................................1-5
Laptop Direct Connect ...........................................1-6
Connecting the Imager with RS-232 Serial Port ....1-6
IBM 4683 Ports 5B, 9B, and 17 Interface...............1-7
Reading Techniques ....................................................1-8
Reading PDF417 Bar Codes..................................1-8
Resetting the Standard Product Defaults.....................1-9
Chapter 2 - Terminal Interfaces
Terminal ID ..................................................................2-1
Supported Terminals....................................................2-2
Keyboard Country ........................................................2-4
Keyboard Style.............................................................2-5
Keyboard Modifiers ......................................................2-6
RS-232 Baud Rate.................................................2-8
RS-232 Word Length: Data Bits, Stop Bits,
and Parity...............................................................2-8
RS-232 Handshaking...........................................2-10
Chapter 3 - Output
Table of Contents
To Next Page
Loading...
Need help?
General