Honeywell 3800G14E - Output Sequence Editor; Require Output Sequence

3800g/3800gHD/3800gPDF User’s Guide 3 - 9
• Discard
This exits without saving any Output Sequence changes.
Output Sequence Editor
Require Output Sequence
When an output sequence is Required , all output data must conform to an
edited sequence or the imager will not transmit the output data to the host
device. When it’s
On/Not Required , the imager will attempt to get the output
data to conform to an edited sequence, but if it cannot, the imager transmits all
output data to the host device as is.
When the output sequence is
Off , the bar code data is output to the host as the
imager decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Enter Sequence
Default Sequence
Required
On/Not Required
* Off