26
6.4 Operation, readers with keypad
6.4.1 Authorization process
There are different possibilities of calling functions. Which of these possibilities is used, is defined
in the programming of the central control unit/EU.
”ID” refers to any data carrier or substitude code, authorized in the system.
The following table provides an overview.
(X) " " " " 5Depends on the authorization of disarm and/or access control function (see 6.4. ).
Quick With the quick function, only the corresponding function key requires activating
(arm / disarm / function "F"). A PIN or data carrier is not required.
Only PIN The function can be triggered after entering the PIN.
Only ID The function can be triggered after reading a valid data carrier.
PIN or ID PIN data carrier are required to trigger the function.
PIN + ID PIN data carrier are required to trigger the function.
or
and
6.4.2 Sequence of operation
If both the PIN and data carrier are required for a function, the sequence of operation can take
place in two ways:
In order for these instructions to remain manageable, the following chapters are limited to
presenting the variation for entering the PIN first.
ID
0....9
ID
0....9
First enter the PIN
Hold the data carrier in the reading field
First, hold the data carrier in the reading field
Enter PIN
or
Function Quick only PIN only ID PIN or ID PIN + ID
Arm X X X X X
Disarm X X X X X
Hold-up alarm X (X)
AC-Functions X X X X
Control functions X X X X X
Info X
Operating Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad
To Next Page
Loading...
Need help?
General
