Honeywell Accentic 026423 User Manual

28
6.4.4 Access control
In case of a hold-up alarm without door release, an acoustic negative acknowledgement
takes place (triggered by the deactivated access control function).
Enter PIN
0....9
and
or
Hold the data carrier in the reading range
ID
possible
6.4.5 Hold-up alarm
6.4.5.1 Introduction
A can be triggered via the operating unit keypad with a hold-up code.
The is identical with the PIN with the exception of the last digit.
(Other digits can be defined via the system programming ).
: PIN 456789
Hold-up code 45678 =
The hold-up code is thus
A possible tens digit is
A hold-up alarm is triggered irrespective of whether the system is in an armed or disarmed state.
Even if the operating unit is used for AC functions, a hold-up alarm can be triggered.
hold-up alarm
hold-up code A 5 is added to the
last digit.
9+5 4
456784
not carried over.
Example
Digit
6.4.5.2 Trigger hold-up alarm in "disarmed" state
possible with door release
possible without door release
Enter the hold-up code
0....9
Hold the data carrier in the reading range
With authorization: A hold-up alarm is triggered
ID
Acknowledgement: Authorization No authorization
Disarmed
(yellow)
Ready
(green)
5 sec.
5 sec.
Operating Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad

Honeywell Accentic 026423 Specifications

General

Brand	Honeywell
Model	Accentic 026423
Category	Card Reader
Language	English