Honeywell AlarmNet 7845i-GSM - Wiring for Module Radio Faults

Internet Communication Module 7845i-GSM Installation and Setup Guide
2-4
CONTROL PANEL
7845i-GSM-006-V0
( )
(+)
7845i-GSM
J1
GND
ZONE INPUT Z1/Z2
ECP (+) VOLTAGE INPUT
2
1
4
5
3
TB1
BATTERY
ADEMCO
K14139
TRANSFORMER
MODEL No. 1332
AC INPUT 2
AC INPUT 1
GND
+12 V AUX
BELL ( )
BELL (+)
Figure 5. Wiring the 7845i-GSM Zone 1 Input for a Ground (-) Triggered Bell Output
LYNXR/LYNXR-EN
CONTROL PANEL
7845i-GSM-019-V0
2K EOL
RESISTOR
LRR / AAV
TRIGGER
7845i-GSM
J1
GND
ZONE INPUT Z1/Z2
2
1
4
5
9
8
TB1
BATTERY
ADEMCO
K14139
TRANSFORMER
MODEL No. 1332
AC INPUT 2
AC INPUT 1
Figure 6. Wiring the 7845i-GSM Zone 1 Input to a LynxR Trigger Output
Wiring for Module Radio Faults
You may wire and program the module's fault output trigger for fail-safe mode (see the
question "FLT REL ON Y/N").
To sense a module fault at the control panel, make connections as shown in Figure 7,
including the proper EOL resistor required by the control.