Honeywell AlarmNet 7845i-GSM - Appendix B: Central Station Messages

Section 7: Appendices
7-5
Appendix B: Central Station Messages
The following messages are sent by the 7845i-GSM module for the conditions listed below.
Table 9: 7845i-GSM Central Station Messages
Alarm Condition
ECP Mode
Alarm Code
ECP Mode
Restore Code
Zone and 4204
Modes
Alarm Code
Zone and 4204
Modes
Restore Code
Power On Reset E339 C08xx* 5551 5555 6
Tamper E341 C08xx* R341C 08xx* 5555 5551 7 5555 5553 7
Power Loss E337 C08xx* R337 C08xx* 1555 5555 6 3555 5555 6
Low Battery E338 C08xx* R338 C08xx* 5155 5555 6 5355 5555 6
Battery Charger Failure E314 C08xx* R314 C08xx* 5155 5555 1 5355 5555 1
ECP Supervision E355 C0000 R355 C0000 5555 5515 5 5555 5535 5
Primary Communication
Path Supervision E350 C0951 R350 C0951 5555 5551 5 5555 5553 5
Secondary Communication
Path Supervision
E350 C0952 R350 C0952 5555 5551 1 5555 5553 1
Swinger Suppression 0D00 0005 0
Telco 5555 5155 6 5555 5355 6
Open/Close
2 sent in
selected zone
4 sent in
selected zone
Test 5555 5555 9 5555 5555 9
* xx = 7845i-GSM Device Address
The control panel sends its own general code (E353) for a trouble condition.