Honeywell AlarmNet 7845i-GSM - Status Codes and Review

Section 3: Programming the 7845i-GSM
3-7
PROMPTS ENTRY OPTIONS DESCRIPTION
44
Gateway IP Addr:
255.255.255.255_
12 digit:
xxx.xxx.xxx.xxx
[0.0.0.0.] = not
used
Enter the 4-part address assigned to the Gateway. The
4 parts of the address must be separated by spaces
(displayed as periods in Review mode).
45
DNS Serv IP Addr:
255.255.255.255_
12 digit:
xxx.xxx.xxx.xxx
[0.0.0.0.] = not
used
Enter the 4-part IP address assigned to the DNS
(Domain Name System) server. The 4 parts of the
address must be separated by spaces (displayed as
periods in Review mode).
46
Review? Y/N
[Y] = review
[N] = exit
Reviewing Programming Mode Entries
To review the programming options (to ensure that the
correct entries have been made), press [Y]. The
programming prompts are displayed again. Use the
up/down arrow keys to scroll through the program
fields without changing any of the values. If a value
requires change, simply type in the correct value. When
the last field is displayed, the “REVIEW?” prompt
again appears.
To exit the programming mode, press [N] in
response to the "REVIEW?" prompt, and refer to
Exiting Programming Mode at the end of this section.
ECP Status Codes
When the 7845i-GSM is configured for ECP mode, it sends status messages to the control
panels for battery, power, tamper, and network connectivity failures. Some of the control
panels (e.g., VISTA-10P, VISTA-15P and VISTA-20P Series) display these on the keypad as
“LngRng Radio” followed by a 4-digit code (listed in Table 4). In addition, the Contact ID
codes (listed in Appendix A) for these conditions are sent to the central station by the
module.
Table 4. Common ECP Keypad Display Status Codes
STATUS CODE DESCRIPTION
0000 Control panel lost communication with 7845i-GSM.
0880 7845i-GSM tamper detected (cover removed).
4005 7845i-GSM has lost contact with AlarmNet.
000F 7845i-GSM is not registered; account not activated.
0019 7845i-GSM shutdown.
0400 7845i-GSM power-on reset AND the control panel lost communications with
7845i-GSM.
0C80 7845i-GSM power on reset AND tamper detected.
0C8F 7845i-GSM power on reset AND tamper detected AND not registered.
08E0 7845i-GSM tamper detected and 7845i-GSM battery low.
3000 Primary power loss (will only be displayed in conjunction with another event).
8000 Battery charger failure (will only be displayed in conjunction with another
event).
0060 Low battery (will only be displayed in conjunction with another event).