Honeywell AlarmNet 7845i-GSM - Network Diagnostics; Running Network Diagnostics

6-1
SECTION 6
Network Diagnostics
•••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
♦ Running Network Diagnostics on the 7845i-GSM
•••••••••••••••••••••••••••••••••••••••••••••••••
Running Network Diagnostics on the 7845i-GSM
The network diagnostic process tests the integrity of the links between the 7845i-GSM and
the various connection points of AlarmNet Control that are known as "Redirs".
To initiate the network diagnostics, press the [F] key on the 7720P Programming Tool.
NOTE: The test is performed ONLY if a physical link is detected. If no physical link is
detected, the test is aborted and the following is displayed:
NO PHYSICAL LINK
If a physical link is detected, the diagnostics are performed. The following shows the
progression of the test:
Testing Redir 1
The first step of the test traces the connection to Redir 1
at AlarmNet Control.
Testing Redir 2
Reached Gateway
A successful trace to Redir 1 is indicated here. See below
for possible errors that may occur at this stage of
testing.
Redir 1
Service OK
The service at AlarmNet Control on Redir 1 is
functioning. See below for possible errors that may occur
at this stage of testing.
Testing Redir 2
The first step of the test traces the connection to Redir 2
at AlarmNet Control.
Redir 2
Service OK
The service at AlarmNet Control on Redir 2 is
functioning. See below for possible errors that may occur
at this stage of testing.
Testing Redir 3
The first step of the test traces the connection to Redir 3
at AlarmNet Control.
Redir 3
Service OK
The service at AlarmNet Control on Redir 3 is
functioning. See below for possible errors that may occur
at this stage of testing.