Section 3: Programming the 7845i-GSM
3-3
PROMPTS ENTRY OPTIONS DESCRIPTION
4
Create Password?
(Y/N)_
[Y], [N]
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program 7845?"
prompt.
If a password is desired, press [Y] and go to "Enter
Password."
5
Change Password?
(Y/N)_
[Y], [N] If a password has already been assigned, this prompt
appears after pressing [N] at the "Program 7845?"
prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key when
prompted for the new password and its confirmation.
6
Enter Password
[0-9, A-F, N, S,
T, X, Y]
This prompt is displayed if [Y] was pressed in Prompt
4 or 5.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
7
[0-9, A-F, N, S,
T, X, Y]
Verify Not OK
PSWD not created
Verify Password
Otherwise, the "Exit Prog. Mode?" prompt is displayed
directly.
8
Exit Prog. Mode?
(Y/N)_
[Y], [N]
[ESC]
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph in
this section.
9
Device Mode
(ECP)_
• ECP
• Zone Triggers
• 4204 Emu
• Two 4204s
Press the [space] key to scroll through the modes of
operation. Press [ENTER] to select ECP mode.
See Table 5 if programming other modes.
Important Information Regarding Primary and Secondary Accounts (Questions 10-16)
Account information is provided by the central station administrator. If the control supports
secondary account reporting, you will need secondary account information. The City ID, CS ID or
Subscriber ID of the secondary account must differ from that of the primary account.
10
Primary City ID
(??)_
[01-99]
Enter the 2-digit primary city ID, 01-99 (decimal).
11
Primary CS ID
(???)
[01-FE] Enter the 2-digit primary central station ID number,
01-FE (HEX).
12
Primary Sub ID
(????)
[0001-9999]
Enter the 4-digit subscriber account number, 0001-
9999 (decimal).
13
En. 2
nd
CS Y/N
(N)_
[Y], [N]
Applicable only if control supports secondary reporting.
Used if redundant reporting to a second central station
is desired.
Press [N], go to Prompt 17: "Device Address."
To Next Page
Loading...
