BENDIX/KING
KAP 140
Page 3--3
Revision 2, Dec/2002
CS:15574F02
3.3.2 DIAGNOSTIC MODE SCREENS
Pressing ‘D’ while the Main Menu screen is displayed will bring up a diagnostic mode confirmation
m essage on t he t er m inal ( Ref er t o Figur e 3 -- 2) . At t his point , t he user should t ype in “ KC140” ( upper
or lower case) followed by the ‘ENTER’ key. If successful, the Diagnostics Menu screen shown
in Figure 3--3 should be displayed. The diagnostic screen allow the user to view the FCC inputs
and control FCC outputs, to validate FCC operation and system interfaces.
NOTE
Pressing the ‘ENTER’ key at the Diagnostics Menu screen will
cause diagnostic mode to be exited.
System mode: Normal
KC 140 Flight Computer
-----------------------
D - Diagnostics
L - Error Log
S - Display SW ID
N - Installation
Press key for desired option :
Please confirm your request to enter Diagnostic mode
by entering ’KC140’:
FIGURE 3--2 DIAGNOSTICS CONFIRMATION SCREEN
System mode: Diagnostic
Diagnostic mode
---------------
V - Read Discrete Input Straps/Valids
S - Read Discrete Input Switches
D - Read Discrete Input Status
O - Write Discrete Outputs
A - Read Analog Inputs
I - Read Analog Voltage Inputs
W - Write Analog Outputs
T - Perform Analog Tests
Press CR to exit :
FIGURE 3--3 DIAGNOSTICS MENU SCREEN
To Next Page
Loading...
