BENDIX/KING
KAP 140
Page 3--26
Revision 2, Dec/2002
CS:15574F02
3.3.12 SOFTWARE IDENTIFICATION SCREEN
Pressing ‘S’ when the Main Menu screen is displayed will cause the Software Identification screen,
similar to Figure 3--14, to be displayed. Pressing ‘ENTER’ when this screen is displayed returns
the user to the Main Menu screen. This screen displays the part number of the software installed
in the FCC.
System mode: Normal
Software Identification
-----------------------
722-20014-0401
Press any key to continue
FIGURE 3--14 SOFTWARE IDENTIFICATION SCREEN
3.3.13 INSTALLATION MODE SCREENS
Pressing ‘N’ when the Main Menu screen is displayed will cause the Installation Menu screen,
shown in Figure 3--15, to be displayed. Pressing the ‘ENTER’ key at this point will return the user
to the Main Menu screen. This screen includes the options necessary to configure the FCC for
proper operation for a particular aircraft installation.
System mode: Normal
SET INSTALL OPTIONS
-------------------
1. Installation Setup
2. Installation Offset
3. Audio Volume (0-7): 4
4. Voice Msg Enabled (B): 1
5. Remote Baro Input (B): 0
6. HSI/DG (1/0) (B): 0
7. Trim Installed (B): 1
8. NAV Force Valid (B): 0
Press key for desired option (<CR> to exit)
FIGURE 3--15 INSTALLATION MENU SCREEN
To Next Page
Loading...
