EAGLEHAWK CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
EN1Z-1005GE51 R0216 10
MOUNTING/DISMOUNTING
Before Installation
IMPORTANT
To allow the evaporation of any condensation resulting from low shipping / storage temperatures, keep the controller at
room temperature for at least 24 h before applying power.
US requirement, only: This device must be installed in a UL-listed enclosure offering adequate space to maintain the
segregation of line voltage field wiring and Class 2 field wiring.
In the case of vertical mounting on DIN rails, the EAGLEHAWK controller should be secured in place using a commercially-
available stopper. See also the EAGLEHAWK - Mounting Instructions (MU1Z-1006GE51).
Dimensions
110
215.5
5245
24 25 26 27 28 29 30 31 32
24V-0
24V~
1
GND1
485-1+
485-1-
GND2
485-2+
485-2-
2
49.5
57.5
J1 J8
RS232
RS485-1
END
BIAS
MID
Fig. 17. EAGLEHAWK controller, dimensions (in mm)
147
57.5
215.5
J1 J8
52
Fig. 18. EAGLEHAWK controller with covers, dimensions (in mm)
NOTE: Use of the covers (MVC-80-AC1) obstructs access to the Ethernet and USB 2.0 Host Interfaces and RS232 socket.
To Next Page
Loading...
